Airmar GH2183, GPS & Heading Sensor Manual do Utilizador descarregar pdf (Página 11)

Cable Routing & Connecting Guidelines

Depending on the equipment you will be using, route the sensor cable to an

Airmar Data Converter, Combiner, an NMEA 0183 display, an NMEA 2000

network, a laptop, or other device. After reading the cautions below, go to the

appropriate instructions.

CAUTION: Do not remove the waterproof connector(s) to ease cable routing. Buy

a cable without a connector. Instructions for wiring are supplied.

CAUTION: To reduce electrical interference from other electrical wiring and any

on-board equipment with a strong magnetic field such as radar equipment, radio

transmitters, engines, generators, etc., separate the cables by at least 1m (3').

Ensure that all the cables shields are appropriately grounded.

CAUTION: Be careful not to tear the cable jackets when passing them through

compartments, bulkheads, or walls. Use grommets to prevent chaffing.

CAUTION: Use a multimeter to check the polarity and the connections to the

power supply before applying power to the sensor.

CAUTION: Coil any excess cable(s) and secure with cable ties to prevent damage.

Connecting to a Data Converter, Combiner, or Splitter

Follow the installation instructions that are supplied with the unit.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Airmar GH2183, GPS & Heading Sensor Manual do Utilizador Página 11